Yaskawa VS-616G5 Series Revision F Programming Manual Manual de usuario descargar pdf (Pagina 71)

VS-616G5 Programming Manual 71

V/f V/f w/PG

Open Loop

Vector

Flux

Vector

F5 DO-02 Set-up

The DO-02C option card has 2 form C type dry contacts. Each of the dry contacts can be individually

set by F5-01 and F5-02.

The DO-02C option card connects to the control board at 3CN.

The table is a list of items that can be selected.

Selects the multi-function output selections for channel 1 of the DO-02C option.

For detailed information on these settings, refer to section H2, Digital Outputs, on page 88.

Setting Range: Same as F5-01

Factory Default: Zero speed (setting = “1”)

Selects the multi-function output selections for channel 2 of the DO-02C option.

F5-01 DO-02C Digital Output Channel 1 Selection DO-02 CH1 Select

A A A A

Setting Description Setting Description

0 During run 1 (factory default) 13 Fref/Fout agree 2

1 Zero speed 14 Fref/set agree 2

2 Fref/Fout agree 1 15 Frequency detection 3

3 Fref/set agree 1 16 Frequency detection 4

4 Frequency detection 1 17 Torque detection 1 (N.C.)

5 Frequency detection 2 18 Torque detection 2 (N.O.)

6 Inverter ready 19 Torque detection 2 (N.C.)

7 DC bus undervoltage 1A Reverse direction

8 Baseblock 1 1B Baseblock 2

9 Option frequency reference 1C Motor 2 selected

A Remote operation 1D Regenerating

B Torque detection 1 (N.O.) 1E Restart enabled

C Loss of reference 1F Overload (OL1)

D DB overheat 20 OH pre-alarm

E Fault 30 Current/torque limit

F Not used 31 Speed limit

10 Minor fault 33 Zero servo end

11 Reset command active 37 During run 2

12 Timer output - --

F5-02 DO-02C Digital Output Channel 2 Selection DO-02 CH2 Select

A A A A

Section F: Option Parameters

F5 DO-02 Option Set-up

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 161 162

Sin comentarios

Yaskawa VS-616G5 Series Revision F Programming Manual Manual de usuario Pagina 71