Yaskawa MP2000 Series: Built-in SVB or SVB-01 Motion Modul Manual de usuario Pagina 84

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 140
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 83
4.3 Motion Parameter Lists
4.3.2 Setting Parameter List
4-8
4.3.2 Setting Parameter List
The following table provides a list of SVB and SVR motion setting parameters.
Refer to the section numbers indicated in the Reference column for details of each setting parameter.
Refer to 1.3 SVR Virtual Motion Module for information on SVR.
The register number “OW00” indicates the leading output register number + 00. Refer to 4.1.1 Motion Parameter
Register Numbers for MP2000 Series Machine Controllers for information on how to obtain the leading output regis-
ter number.
Register No. Name Contents SVB SVR Reference
OW00
RUN Command
Setting
Bit 0: Servo ON (0: OFF/1: ON)
Yes Yes
4.4.2 ( 1 )
Bit 1: Machine Lock (0: Normal Operation/1: Machine Lock)
Yes
Bits 2 to 3: Reserved for system use
−−
Bit 4: Latch Detection Demand (0: OFF/1: ON)
Yes
Bit 5: Reserved for system use
−−
Bit 6: POSMAX Turn Number Presetting Demand
(0: OFF/1:ON)
Yes Yes
Bit 7: Request ABS Rotary Pos. Load (Absolute system infinite
length position information LOAD)
(0: OFF/1:ON)
Set to 0 for linear type
Yes
Bit 8: Forward Outside Limiting Torque/Thrust Input (Forward
external torque/thrust input)
(0: OFF/1: ON)
Yes
Bit 9: Reverse Outside Limiting Torque/Thrust Input (Forward
external torque/thrust input)
(0: OFF/1: ON)
Yes
Bit A: Reserved for system use
−−
Bit B: Integration Reset (0: OFF/1: ON)
Yes
Bit C: Reserved for system use
−−
Bit D: Latch Completion Status Clear Request (0: OFF/1: ON)
Yes
Bit E: Communication Reset (0: OFF/1: ON)
Yes
Bit F: Alarm Clear
Yes Yes
OW01
Mode Setting 1
Bit 0: Excessive Deviation Error Level Setting
(0: Alarm/1: Warning)
Yes
4.4.2 ( 2 )
Bits 1 to 2: Reserved for system use.
−−
Bit 3: Speed Loop P/PI Switch
Yes
Bit 4: Gain Switch
Yes
Bit 5: Gain Switch 2
Yes
Bit 6: Latch Mode Selection
Yes
Bits 7 to F: Reserved for system use.
−−
OW02
Mode Setting 2
Bit 0: Monitor 2 Enabled (0: Disabled/1: Enabled)
Yes
4.4.2 ( 3 )
Bits 1 to 7: Reserved for system use.
−−
Bits 8 to F: Stop Mode Selection
Yes
Vista de pagina 83
1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 139 140

Comentarios a estos manuales

Sin comentarios