Yaskawa MP2300S Basic Module Manual de usuario descargar pdf (Pagina 276)

6.4 Communication with PLC Manufactured by Mitsubishi Electric Corporation (MELSEC protocol)

6.4.2 When the MP2300S Acts as Master (I/O message communication function is used)

6-87

Built-in Ethernet Communications

 Caution

In I/O message communications, since a message is transmitted from each port number for register read/write, a connected

remote device needs the two receive connections for receiving messages.

i Set a storage area (Input Reg) for data read by the MP2300S (IW0000, for example).

j Set Read Size of data to be read by the MP2300S (“100” W, for example).

k Set a storage area (Output Reg) for data written by MP2300S (OW0064, for example).

l Set Write Size of data written by the MP2300S (“100” W, for example).

Set an I/O data update timing (Data update timing) for the CPU and built-in Ethernet (“Low” scan, for exam-

ple).

 Data Update Timing

Data update timing indicates when to give and receive data between the CPU and built-in Ethernet. Communication with the

remote device is carried out asynchronously, so note that a message is not necessarily transmitted to the remote device at each

data update timing.

Set the register type and start address (Read Reg) of the remote device (MELSEC Q series) read by the

MP2300S (“D00000,” for example).

Set the register type and start address (Write Reg) of the remote device (MELSEC Q series) written by the

MP2300S (“D00100,” for example).

Click OK.

5. Click Yes in the parameter setting confirmation dialog box.

 Caution

Note that when a parameter with the same connection number is already set and you click Yes in the parameter setting confirma-

tion dialog, the setting will be overwritten by the parameter configured in the Message Communication Easy Setting Window.

6. Check the setting values.

The I/O message communication is now set up, when the MP2300S acts as a master.

 Caution

When any transmission or connection parameter is changed, the change will be reflected after FLASH has been saved and the

power supply is turned ON again.

1 2 ... 271 272 273 274 275 276 277 278 279 280 281 ... 459 460

Sin comentarios

Yaskawa MP2300S Basic Module Manual de usuario Pagina 276