Yaskawa iQpump Controller Programming Manual Manual de usuario descargar pdf (Pagina 201)

YASKAWA TM.iQp.07 iQpump Controller Programming Manual 201

Table 76 Alarms <0034>

Table 77 Multi-Function Output Setting <0034>

◆ P4-12 Pre-charge Frequency 2 <0034>

Setting Range: 0 ~ 120.00 Hz

Factory Default: 0.00 Hz

Refer to parameter P4-12 in Appendix A for description details.

◆ P4-13 Pre-charge Time 2 <0034>

Setting Range: 0 ~ 3600.0 min

Factory Default: 0.0 min

Refer to parameter P4-13 in Appendix A for description details.

◆ P4-14 Two Motor Alternation Selection <0034>

This parameter allows one drive to power two motors in an “OR” configuration to keep the amount of wear on each motor / pump

balanced. This feature will utilize one digital output, which will drive two output contactors via a form-C pilot relay. This feature is only

available in Simplex mode (P1-01 = 0).

Alarm Display Description Cause Countermeasures

Utility Delay Adjust by

P4-11

Utility Delay

This message will appear when the drive is delaying

the run command due to the Utility Start Delay

Function.

Wait until the P4-11 time to elapse, or cycle the run

command.

Setting Description

Utility Delay

Closed: Drive is stopped and is waiting for the utility delay timer to expire. (configured by P4-11)

Setting Description

0Disabled

1 Enabled

2 Motor 1 Only

3 Motor 2 Only

1 2 ... 196 197 198 199 200 201 202 203 204 205 206 ... 301 302

Sin comentarios

Yaskawa iQpump Controller Programming Manual Manual de usuario Pagina 201