Yaskawa Modicon 800 Series Remote I/O Network for use on M Manual de usuario descargar pdf (Pagina 6)

Table 2. Modicon I/O Interface Card Setup

indicates if

off

card is loaded with software

LED1 green

card is (normal)

LEDs loaded with

card needs to be loaded with

software software

LED2 red power indicator

off no power to gateway

on power on gateway (normal)

Connector bnc connects to Modicon remote i/o network

the host computer

base port address 1 2 3 4 5 6

uses a block of

Switch S1 8 I/O address to 0x260 o o o o o o

control the operation (default) n n f f n n

of the card (download) f f

enable power up enabled (default) 2-3

memory disabled 1-3

Jumpers base address J4 J5

the interface card uses 0x9000 2-3 2-3

J4, a block of 64K bytes of 0xA000 1-3 2-3

J5 memory in the host 0xC000 1-3 1-3

computer 0xD000 (default) 2-3 1-3

method of grounding through R-C circuit cap (default)

bnc shield directly to ground direct

HARDWARE

Modicon I/O Interface Card

5/24/96

This card is connected to the Modicon 800 Series I/O network using a coaxial

cable connected to the BNC connectors on the front of the card. It is

connected to the network in the same way as the real drops. Refer to the

Modicon installation guide for information on appropriate types of cable.

CAUTION

The card does not contain a 75-ohm termination resistor, so an

external resistor is necessary at the card end of the cable. (Use

supplied bnc in-line terminator.)

Modicon I/O

Interface Card

RD 3004-20

1 2 3 4 5 6 7 8 9 10 11 ... 25 26

Sin comentarios

Yaskawa Modicon 800 Series Remote I/O Network for use on M Manual de usuario Pagina 6