YASKAWA NX100 Manual de usuario descargar pdf (Pagina 10)

10/63

3 BASIC OPERATION

3.1 Basic Concept and Operation Flow

3.1.1 Difference from MRC-World

The MRC-World is the previous software version of the Job EditorNX.

For basic operations, the MRC-World uses CMOS.HEX as a file unit, but the Job EditorNX

uses *.JBI file units. Therefore, the Job EditorNX cannot read in CMOS.HEX directly.

For managing each robot, the MRC-World required registration of the robots at the beginning,

however, such robot registration is no longer required for the Job EditorNX. To manage each

robot with the Job EditorNX, simply create a folder and input the parameter file and the job file

to be edited into the folder.

3.1.2 Operation Flow

This software requires only parameter files. To edit the same instructions as the programming

pendant, save the parameter file from the programming pendant in advance.

3.1.2.1 Saving a Parameter File (ALL.PRM)

Use the YASKAWA FC2 or FC1-Emulator to save ALL.PRM and the job file to be edited from

the programming pendant.

3.1.2.2 Creating a Folder

Create a folder anywhere on the personal computer, and copy the parameter file and job file that

have been saved from the programming pendant to the folder.

3.1.2.3 Editing

Use the Job EditorNX to open the job file and save it after editing.

3.1.2.4 Loading to the Programming Pendant

Load the edited file to the programming pendant using the same procedure as described in

paragraph 3.1.2.1.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 61 62

Sin comentarios

YASKAWA NX100 Manual de usuario Pagina 10